pfSense 2.4.4 selective Routing

  1. In order to setup pfSense selective routing, please set up OpenVPN first on your pfSense following our tutorial.

    Note: On the Tunnel Settings, mark the checkbox on Don't pull routes option.
     
  2. Once you have finished the tutorial, navigate to Firewall → NAT → Outbound. You will need to readjust Mappings according to the screenshot:

    Manual Outbound NAT 모드와 NORDVPN 인터페이스 항목이 있는 Mappings 테이블을 보여주는 pfSense Firewall NAT Outbound 페이지
     
  3. Navigate to Firewall → Rules → LAN.
     
    1. Click to Add new interface. Change the following settings:

      Action: Pass
      Interface: LAN
      Protocol: Any
      Source: Single host or alias → device IP address you wish to exclude from VPN tunnel. (You can write a whole subnet, range of IP addresses as well)
      Gateway: WAN_DHCP

      Action Pass, Interface LAN, Protocol Any, Source가 단일 호스트 192.168.11.3으로 설정된 pfSense Edit Firewall Rule 양식
      Gateway가 WAN_DHCP로 설정된 pfSense Edit Firewall Rule Advanced Options 섹션

      Once you will save changes, your LAN rules should look similar to:

      기본 NordVPN 규칙 위에 소스 192.168.11.3에 대한 새 규칙이 WAN_DHCP 게이트웨이와 함께 표시된 pfSense Firewall Rules LAN 탭

      Note: make sure this newly created rule is placed above any other rules.
       
  4. Save and apply changes. You may also need to reset the firewall to apply all changes, which you can do by:
  5. Navigate Diagnostics → States → Reset States → Check Reset the firewall state table → Reset.
  6. That is it, you can check our IP check website to see whether your devices are routed through ISP connection and rest of them via VPN tunnel.
이 게시글이 도움이 되었나요?

여전히 문제가 지속되나요?

  • 라이브 채팅

  • 이메일 양식

“지원 팀과 채팅”를 클릭하면, 귀하는 당사의 서비스 약관에 동의하고 개인정보 처리방침을 확인하는 것으로 간주됩니다. 채팅 기능은 쿠키를 사용합니다. 채팅을 시작하면 쿠키 사용에 동의하게 됩니다. 자세한 내용은 다음을 참조하세요. 쿠키 정책.